National Aeronautics and Space Administration Logo
Follow this link to skip to the main content NASA Banner
Solar System Exploration
News & Events
CU Experiment to Explore Physics of Space Dust Collisions Aboard Shuttle
CU Experiment to Explore Physics of Space Dust Collisions Aboard Shuttle
21 Nov 2001
(Source: University of Colorado at Boulder)

Office of News Services
University of Colorado-Boulder
3100 Marine Street, 5th Floor
584 UCB
Boulder, Colorado 80309-0584
(303) 492-6431

CONTACT:
Joshua Colwell, (303) 492-6805, colwell@lasp.colorado.edu
Preston Dyches, (303) 492-4352

A University of Colorado at Boulder experiment will ride into orbit on a NASA space shuttle to explore gentle collisions between particles of space dust - a fundamental process in the formation of planets and the evolution of planetary ring systems.

The payload, dubbed COLLIDE-2, or Collisions Into Dust Experiment Two, is part of the MACH-1 payload currently scheduled for launch on the space shuttle Endeavour on Nov. 29. COLLIDE-2 continues the research into the dust collisions where its predecessor, COLLIDE, left off in April 1998.

COLLIDE-2 will perform six independent impacts of small quartz spheres into fine quartz sand. The impacts will be videotaped by two small camcorders, allowing the CU team to analyze the amount, direction and speed of dust ejected from the target trays by each impactor.

The experiment will provide data on the release of dust from the type of collision that occurs in planetary rings, and perhaps during the early phases of planet accretion.

According to Joshua Colwell, a research associate at CU-Boulder's Laboratory for Atmospheric and Space Physics, COLLIDE has undergone improvements and modifications for its re-flight on Endeavour. The major features COLLIDE contained all are present in COLLIDE-2, although the projectile launchers, doors, and camera containers all were redesigned after parts of the components failed to fully operate in the original experiment.

Changing the target material also was an important priority, said Colwell. The first COLLIDE experiment used a fine powder called JSC-1, which is similar to lunar dust. "We found that the finer material gets compacted during launch and does not behave in the way it should during the experiment." This time, only one of the six experiment boxes will contain JSC-1, while the other five will contain the grainy quartz sand.

"We've also switched from a Teflon projectile to a quartz one to make the material interactions more realistic," he said.

COLLIDE-2 is one of three experimental programs underway at LASP to study the physics of low-energy collisions in space. Planetary ring systems, protoplanetary disks, the asteroid belt and Kuiper belt are all collisionally evolved systems. However, little is known about the dissipation of energy, the production of ejected materials and accretion in the low-speed collisions that occur between objects with low-surface gravity like planetary ring particles.

Although dust is ubiquitous in the rings of the four gaseous giant planets, how the dust is "knocked off" larger ring particles a meter or more across during their continuous collisions with each other remains a mystery.

"The rings are comprised primarily of large particles, but we see dust throughout the rings," said Colwell. "The dust is short-lived, so it acts as a very sensitive tracer of the dynamics of the larger particles. But to understand that, we need to understand each step in the life cycle of a dust particle," he said.

The enormous gravity of Earth prevents researchers from doing the type of experiment contained in COLLIDE-2 on the ground, said Colwell. "In order for the dust to behave the way it would in the space environments being simulated, we need to get into a microgravity environment."

COLLIDE-2 was designed and assembled primarily by LASP students, under the direction of LASP faculty, instrument assemblers and engineers. Colwell is the principal investigator and LASP researchers Larry Esposito and Mihaly Horanyi are co-investigators.

Most of the experiment's electronics were designed for the original COLLIDE by former graduate student Barry Arbetter of CU-Boulder's electrical engineering department. Tom Calihan and Dave Crotser were the primary students involved in the re-design work for COLLIDE-2. Other present and former CU-Boulder students who worked on COLLIDE-2 include Andrew Diaz, Andreas Lemos, Darren Curtis, Jeff Gonder and Matt Kanter.

In addition, Adrian Sikorski, an undergraduate at the Colorado School of Mines in Golden designed and built several COLLIDE-2 components.

COLLIDE-2 was funded by NASA's Microgravity Sciences and Applications Division through the Innovative Research Program and NASA's Lewis Research Center.

For photos and additional mission information, visit the official website of COLLIDE-2 at:
http://lasp.colorado.edu/collide/

News Archive Search  Go!
Show  results per page
 
 
Awards and Recognition   Solar System Exploration Roadmap   Contact Us   Site Map   Print This Page
NASA Official: Kristen Erickson
Advisory: Dr. James Green, Director of Planetary Science
Outreach Manager: Alice Wessen
Curator/Editor: Phil Davis
Science Writer: Autumn Burdick
Producer: Greg Baerg
Webmaster: David Martin
> NASA Science Mission Directorate
> Budgets, Strategic Plans and Accountability Reports
> Equal Employment Opportunity Data
   Posted Pursuant to the No Fear Act
> Information-Dissemination Policies and Inventories
> Freedom of Information Act
> Privacy Policy & Important Notices
> Inspector General Hotline
> Office of the Inspector General
> NASA Communications Policy
> USA.gov
> ExpectMore.gov
> NASA Advisory Council
> Open Government at NASA
Last Updated: 26 Nov 2001